国产精品第一页九一桃色_激情国产精品欧美日韩免费看中文字幕三级专区_国产午夜视频专区在线观看_国产美女被操网站_亚洲欧洲国产成人综合91

歡迎訪問濟南立強模具有限公司!

當前位置:首頁-新聞中心-公司新聞濟南注塑模具回彈是什么原因?

濟南注塑模具回彈是什么原因?

來源:http://m.55film.com/ 日期:2022-02-26

在注塑加工中有時模具開到底后還會彈回20mm左右,這里濟南注塑加工廠就來說說注塑模具回彈是怎么回事?
In injection molding, sometimes the mold will bounce back about 20mm after it is opened to the end. Here, Jinan injection molding factory will talk about the rebound of injection mold?
1.開模行程設定不合理,緩沖速度壓力太大,位置太小。
1. The setting of mold opening stroke is unreasonable, the buffer speed pressure is too large, and the position is too small.
2.開模油缸有空氣也會有此現象。
2. This phenomenon also occurs when there is air in the mold opening cylinder.
3.應該是在頂出時慢慢爬行20mm吧,如果是這樣就檢查合模閥。
3. Crawl slowly for 20mm during ejection. If so, check the clamping valve.
4.先查換向閥中位情形及油缸密封件.還有壓力的斜率
4. Check the center position of the reversing valve and the sealing parts of the oil cylinder first And the slope of pressure
5.通過沉頭螺絲調節開合調節開合模換向閥內部導引油小孔子(X、Y)可緩解
5. Adjust the opening and closing by countersunk screws. The small Confucius (x, y) in the opening and closing die reversing valve can be relieved
6.還有可能是油箱空氣濾芯堵塞排氣不暢!
6. It is also possible that the air filter element of the oil tank is blocked and the exhaust is not smooth!
濟南注塑模具
7.開鎖模油缸內泄.檢查活塞密封圈和活塞與活塞桿之間螺紋內泄。
7. Internal leakage of unlocking die cylinder Check the internal leakage of the piston sealing ring and the thread between the piston and the piston rod.

相關產品 / Related products

濟南立強模具有限公司

網站地圖    TXT    XML 魯公網安備 37010502002026號